|
It is currently Fri 22. Nov 2024 19:30:29
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 2 posts ] |
|
| Author |
Message |
|
Malc1
|
 Posted: Sat 09. May 2015 23:32:39 |
|
Joined: Thu 07. May 2015 22:33:47
Posts: 169
|
|
Are there any recommended servo arm ball distances listed for this system?
This would be for the cyclic and rudder servo's.
Helicopter is a Gaui NX7 with MKS servo's.
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Sun 10. May 2015 9:07:52 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
There are no recomendations, but basically you can determine which distance is fine.
If your rudder limits are too low, then the arm is too long. So then you can put shorter one. It should be approx. between 1/3 to 1/2 for the best performance.
Similarly with the cyclic. Here you should check Geometry 6° value. Values of 128 and higher are fine.
_________________
Spirit System developer
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: Bing [Bot] and 47 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
