Hello all!

I checked forum, but I didn't find anything to help me with this. I really hope I didn't miss anything that already has answer to my problem.
I started to setup Spirit on my old flybarred Gaui Hurricane 550 (to try it out) and everything seems to work ok, but the rudder.
When I move the stick, servo moves only for a few degrees in each direction. On transmitter display (Graupner MX22), output shows -100% to +100% and same on Spirit (in "Diagnostics" tab).
I tried everything with "Rudder end-points" setting in "Limits" tab, but looks like it doesn't have any effect.

I'm using two Spektrum satellites in DSM2 mode (if this has anything to do with anything ).
My rudder servo is Futaba S9254 and I set pulse to 1520 and frequency to 200Hz.

What I missed or what I did wrong?
I don't know what extra information I can give you, so please tell me what else you need to help me solve this problem.

Thanks!
Matic

I have observed the same behaviour if you set the rudder to normal mode - if you switch to headling lock mode the rudder will move all the way.

Yes! That was it!
I can't believe I didn't think of gyro channel. Really stupid of me!
Channel input was at 0% and it was in normal mode because of this. Now I can also set limits if I switch it to HL.

Thank you very much!

Matic