ZeXx86 wrote:
We are testing with Hobbywing V3 Platinum ESCs and also some V2 for very long time without one issue.
I believe that there is rather coincidence.
Sometimes people do not reveal all connected stuff as loggers, telemetry modules that are not compatible and are inducing additional problems.
Hi thanks you for your reply i now believe i have resolved the issue of the tail to nose wobble, over the weekend i replaced the MKS cyclic servo with some cheep align DS430, i was unable to test fly as the wind was to high but today there was a short spell were the wind dropped so i managed to get a very short hover/circuit done and there was no wobble modal was very solid.
However when looking at the flight log after a 2min flight all it showed was 3 entry's;-
Calibration finished, receiver signal lost, power voltage low.
I then disconnected the battery, reconnected and had another short flight, this time the log showed lots of good health but also showed rudder limit reached and cyclic ring activated.
regards alan
