Hi,

I did some search in the forums, but did not get a clear answer, it is probably very easy.

I want to switch banks via a 3-way switch (mix0,1,2) on Devo 12. Now, which value do I have to send via channel 5 (I am using RX801 Devo 8 channel receiver) to the RX to trigger bank 0, 1, 2?

I understand that I am not actually sending any value that is used within the Spirit, but depending on which bank I activate, the Spirit uses all the configuration connected to that bank.

So, I need to tell my devo 12s (running deviation freeware) the value it should send on switch position mix0, 1,2 .

Thanks,

Michael

Hi,

first from all you have to configure Bank function to Channel 5 in the software.
Then you simply can set values in the TX in this way:
-100% - Bank 0
0% - Bank 1
100% - Bank 2

_________________
Spirit System developer

Thanks!!