Version 1.8.0 - ChangeLog:It brings many new features and improvements:
- Spirit Wave support:
- Full support for Spirit Wave, Spirit W1 and Spirit RX7 devices.
- For full integration with Spirit Wave use the latest 1.0.21 Wave firmware.
- Support for separate Limits for each Servo:
- Each servo can be configured separately allowing unequal throws for doubled servos.
- Support for 6 Servos:
- From now Spirit units allow to connect also secondary Rudder Servo with AUX/AUX2 port.
- Support for 760us Neutral Pulse Servos:
- All Spirit units can utilize Servos running at 760us.
- New Smoothing Factor for Stabi/Rescue modes:
- All transitions between modes (engaging/disengaging) can be smoothened to prevent excess stress.
- Use Smoothing Factor parameter available at the Stabi tab.
- New Spektrum Avian ESC telemetry support:
- Full support for Spektrum Avian ESC telemetry.
- Spirit GT, Spirit GTR, Spirit W1 are supported.
- See wiring and settings at the Wiki page.
- Full support for CRSF/ELRS telemetry:
- Spirit units are able to send telemetry now.
- Available sensors are:
- Battery Voltage
- Battery Current
- Used Capacity
- Vibration Level
- GPS Latitude
- GPS Longitude
- GPS Speed
- BEC Voltage (reported as GPS Heading)
- GPS Satellites
- Altitude
- Graupner HoTT telemetry:
- Spirit units will accept telemetry from Graupner HoTT ESCs configured as GAM, EAM and ESC sensors.
- Previously only EAM sensor was supported.
- UniSense-e telemetry support:
- Spirit units will accept telemetry from UniSense module configured as Graupner HoTT now.
- Using HoTT ESC will give you the most telemetry variables.
- FrSky F.BUS protocol:
- MicroSpirit units can use F.BUS protocol with FrSky integration cable.
- FrSky Integration cable for microSpirit is recommended.
- Added new protocol JR XBUS mode A:
- Brand new protocol for native support of JR XBUS receivers.
- Telemetry support will be availble in next updates.
- ESC telemetry in the Spirit Aero software:
- Spirit Aero software can display ESC telemetry values directly in the software now - Advanced/ESC Telemetry window.
- All telemetry enabled ESCs can be interfaced with Spirit units also with Radio System that has no telemetry support.
- New OMP/ZTW ESC telemetry support:
- Full support for OMP Hobby, ZTW and compatible ESC telemetry.
- See wiring and settings at the Wiki page.
Update for the
Spirit units is available in our
Download section.
WARNING: New limit settings is required after updating!
