|
It is currently Fri 22. Nov 2024 18:19:04
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 6 posts ] |
|
| Author |
Message |
|
Gerdklaus
|
 Posted: Tue 25. Jul 2023 8:37:43 |
|
Joined: Thu 21. Jul 2022 20:22:32
Posts: 16
|
|
Hello Thomas,
on the last attempt to take off, the heli suddenly pitched forward and damaged the main rotor blades. I didn't touch any sticks.
During the test run, the swash plate trembled several times.
I show that in the video.
What could be the problem.
In the last flights (2022) everything was normal.
The heli didn't crash.
Greetings Gerd
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Tue 25. Jul 2023 8:40:39 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
Hello,
it look like a strong static discharges.
Is your receiver wiring PWM?
Or are you using a digital protocol? With PWM this kind of problems is much more apparent.
_________________
Spirit System developer
|
|
| Top |
|
|
|
Gerdklaus
|
Posted: Tue 25. Jul 2023 9:35:23 |
|
Joined: Thu 21. Jul 2022 20:22:32
Posts: 16
|
|
Hello,
I don't think it's static discharge.
I installed an equipotential bonding.
I am using a Futaba FASSTest receiver with Sbus2.
Next I swap all 3 TS servos.
Greetings Gerd
|
|
| Top |
|
|
|
ZeXx86
|
Posted: Tue 25. Jul 2023 12:00:55 |
|
|
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
The issue is not caused by servos. I would look for receiver wiring.
Please describe how it is all wired. Are some telemetry sensors used?
_________________
Spirit System developer
|
|
| Top |
|
|
|
Gerdklaus
|
Posted: Tue 25. Jul 2023 12:15:17 |
|
Joined: Thu 21. Jul 2022 20:22:32
Posts: 16
|
|
I use a UniSens-E current sensor on the Sbus2.
The sensor was installed in 2022 and has not flown since then. I will remove the sensor and test again.
|
|
| Top |
|
|
|
Gerdklaus
|
Posted: Tue 25. Jul 2023 15:19:08 |
|
Joined: Thu 21. Jul 2022 20:22:32
Posts: 16
|
|
The problem is solved. Without telemetry there is no more shaking.
One last question:
When i switch the altitude limit and when i switch the rescue, does the swashplate have to go up and then down again after 1.5s?
With my system, the swashplate (on the table) always stays up, so the heli would always climb.
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 6 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: mainstreet and 6 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
