Spirit System • View topic - Spirit GT , Function "Rescue normal" issues

It is currently Sat 23. Nov 2024 23:32:38

View unanswered posts | View active topics

Board index » English » HELI » Support

All times are UTC + 1 hour

Spirit GT , Function "Rescue normal" issues

Page 2 of 2

[ 14 posts ]

Go to page Previous 1, 2

Print view

Previous topic | Next topic

Author

Message

ZeXx86

Post subject: Re: Spirit GT , Function "Rescue normal" issues

Posted: Mon 12. Jul 2021 7:59:40

Site Admin

Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442

If I understand it correctly, you can see also other problem with rescue changing angle - later after few minutes it does not work correctly, right?

If this is the case, you can check this page:
http://manual.spirit-system.com/index.p ... ise_Rescue

_________________
Spirit System developer

Top

Dr.Fleming

Post subject: Re: Spirit GT , Function "Rescue normal" issues

Posted: Mon 12. Jul 2021 8:26:53

Joined: Sun 18. Apr 2021 16:54:57
Posts: 216

ZeXx86 wrote:

Hello,

it is not possible to set Rescue (Automatic) to run in background while using other Stabi mode at the same time.
This is possible only with GeoLink Altitude Limit - you will enable F: GeoLink Altitude Limit in the General/Channels with assigned channel.

No need to use Bank Switching at all.

Good morning thanks for the reply, as you can see ( Youtube) this user make it works with his Jeti Transmitter,
also it is not a "GT" Hardware problem, it is a Software Design problem.

https://www.youtube.com/watch?v=TLPrb8yV0Qo

Top

ZeXx86

Post subject: Re: Spirit GT , Function "Rescue normal" issues

Posted: Mon 12. Jul 2021 8:32:00

Site Admin

Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442

You can change between Rescue modes or Stabilisation modes with only one switch.
It is enough to set Sensor/Rudder Gain to a negative value for stabi function.
Then even 6 channel radio is enough. Settings is same for all Spirit units.

_________________
Spirit System developer

Top

Dr.Fleming

Post subject: Re: Spirit GT , Function "Rescue normal" issues

Posted: Mon 12. Jul 2021 8:41:06

Joined: Sun 18. Apr 2021 16:54:57
Posts: 216

ZeXx86 wrote:

Please add the basic function "Rescue Normal" in the channel selection window P:
then it is possible.
There is so many function to chose in this window, that normally not need most of them.

Not need ruder gain, for user with transmiters and enough channels .

Top

Page 2 of 2

[ 14 posts ]

Go to page Previous 1, 2

Board index » English » HELI » Support

All times are UTC + 1 hour

Who is online

Users browsing this forum: No registered users and 23 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: