Yesterday Test flight, to see how it works the minimum altitude programmed with the Spirit GT presure sensor,
the Heli still goes direction to the ground , after passing the minimum programmed 10 meters.
On the PC I see "Activated" when I select the on function on the transmitter.

Please post a backup from your settings and a Picture of your Spirit Unit on the Helicopter.

Thank's for the quick reply, here a Picture of my Heli's and a Youtube Link with one of the first Test Flight with my Kraken, also I have to say again , I like the Factory setup just out of the Box, will Try to fine tune this weekend but I think not much to do.

Of the other side my Goblin 500 GeoLink Test Rabbit not like to do the GeoLink functions, even I see on the Software it works showing "ACTIVE".

And my other Goblin 500 Red white Test Rabbit not like to do the basic GT's functions , like the altitude limit.
Even I see on the Software it works showing "ACTIVE".

Also the Kraken Test Rabbit I like it .

As you see on the picture I do not have a problem with Channel's quantity and Functions, ( from Transmitter side)



https://www.youtube.com/watch?v=PSlDV4L4mC0

By the way it was strong wind , you can hear it in the video.

And where is the Backup file (*.4ds) ?

Thank's a lot for the quick reply, here all backup's from all Bank's.

Only limit3 is configured as Automatic rescue. Did you use that Bank while testing with activated Rescue switch?

Yes I use Bank 0, 1, 2. Also as I mention I see on the Sofware that the Functions selected by the Transmitter,
it changes to "Activate" I double check it on the Transmitter Servo Windows and the selected channel are working, I select on the Transmitter a spring back switch that I selected for Rescue normal, but I see on the software ,
example when the Minimum altitude is selected, that the normal rescue selected with the other switch doesn`work too.

But like I write before , even the minimum altitude is not working, as I read it must stop at the minimum altitude pre-programmed and gave the Heli par example 60% Pitch to continue the rescue. But nothing happen.

I am not sure. But i think you have to switch on the rescue with a normal switch in the bank where the automatic rescue is activated.Not momentary. So you chose the auto rescue bank and switch the rescue on (in your case channel 8)with a normal switch while flying(not momentary).

Gesendet von meinem Mi 9 Lite mit Tapatalk

Hi sorry I not explain very well my english writing is not of the best, I have the function rescue normal on the momentary switch.
And the minimum altitude ( automatic rescue by goin more down to the ground on pregrommaed 10 meters) is on a 3 way switch.

German?

Gesendet von meinem Mi 9 Lite mit Tapatalk