Hello!
Unfortunately, my Geolink is not detected. Geolink is connected to SAT1 of Spirit-RS unit. Within a 15-20 sec upon boot up Geolink is solid blue. When I connect USB cable to SYS-port on Spirit-RS and startup Spirit Software, then open General (Geolink Module is enabled). After I click Settings it says: "Link: Not connected". Note that the light on Geolink is still on (see attached photos).
What should I do? How can I get my Spirit unit to be recognized? Let me know if any additional information is required.
What I have tried:
1. I tried to flash the Geolink (even though it was not detected) using geolink-fw-1.2.0.4dg in both regular and recovery mode. However, both attempts failed as the Geolink unit was not detected.
My Setup: w/ Spirit-RS on firmware: 3.1.0
Cyclic: 3xDS-3001HV
Tail: 1xDS5005HV
Motor: Xnova 3215-930
ESC: Castle Lite 75 w/ 10am BEC
Geolink Serial: 5d-1d-d3-dc-04 (if that will help)
Attachment:
File comment: Geolink
Screen Shot 2020-09-20 at 11.17.30 AM.png [ 246.57 KiB | Viewed 121 times ]
