Spm6210t & ix12 and spirit 2

Neilsteers · **Joined:** Tue 05. May 2020 22:02:02 **Posts:** 18

Looking for help, have the 6210t connected to the spirit by JETI cable red and brown rudder and orange to pit, esc to aux1 , if I connect servos to rx they respond but connected to the spirit 2 they don’t and in both scenarios the bars do no move in the channel screen in the spirit wizard, what am I doing wrong ?

10x · **Joined:** Wed 04. Jul 2018 18:03:55 **Posts:** 180

I assume you mean the 6610t?. Have you set receiver type to SRXL2 in the Spirit in the general tab, then in rx....

Neilsteers · **Joined:** Tue 05. May 2020 22:02:02 **Posts:** 18

Hi
Yes the 6610t, and yes set to srxl2

HeliMLM · **Joined:** Tue 10. Mar 2020 14:36:22 **Posts:** 370

Neilsteers wrote:

.....and orange to pit...?

if you have really connected to PIT (middle pin) this is the problem... check wiring with Spirit manual: should be the topmost pin iirc.

Neilsteers · **Joined:** Tue 05. May 2020 22:02:02 **Posts:** 18

Hi Michael no the orange wire is in the top pin

HeliMLM · **Joined:** Tue 10. Mar 2020 14:36:22 **Posts:** 370

Ok... would have been an easy one

and the firmware on 6610T is updated and Spirit is using actual firmware?

latjo-k · **Joined:** Fri 06. Dec 2019 8:22:54 **Posts:** 131

HI follow this thread.
viewtopic.php?f=20&t=3791

Neilsteers · **Joined:** Tue 05. May 2020 22:02:02 **Posts:** 18

I have updated the rx but not the spirit software, software on wizard is showing latest release 2.8

Spm6210t & ix12 and spirit 2

Who is online