Are you powering up the receiver with a battery? when connected to the PC.

... and is Spektrum Programmer App logged into your Spektrum account? (left, upper) there should be written "Logged in as" & your Spektrum account (first) name...

_________________
cheers
Michael

i have tryed with and without a battary.
without a battery i have put the check "power cabel"
an the receiver is slowly blinking.

now it works
I first connected the cable to channel one.
Then I connected it to the bind channel.

Thanks to for help!

Well done, As you found out it needs to plug into data port and will work with the spirit through this port. But if you use a 4651T as a sat with the 6610T you will need to use port 1 to the spirit....

ok,
thank you for the information.
but port 1 is for the gas channel right?

If it see's a srxl2 signal within the first 500Ms it reverts to SRXL2..
Correction from Chris: It is 200ms....not 500ms..

hanks good to know

Small correction: if a device wants to communicate via SRXL2 on the throttle port, it must answer within 200 milli seconds.
If a SRXL2 receiver does not get the handshake within that period, it will revert to "normal" PWM mode, see Specification for Spektrum® SRXL2.

chris

@10x... as you are 'playing around' a lot with srxl2 too... did you test failsafe? how is your experience? as i my parallel thread... i am in trouble with it not working

_________________
cheers
Michael