|
It is currently Mon 25. Nov 2024 0:37:27
|
View unanswered posts | View active topics
|
Page 1 of 1
|
[ 4 posts ] |
|
Author |
Message |
DonHoutz
|
Posted: Mon 09. Dec 2019 15:38:18 |
|
Joined: Sun 08. Dec 2019 19:48:46 Posts: 2
|
I am current setting up a Spirit Pro/Geolink with a DX8 on a TREX600 Nitro. I cannot figure out how to assign all the functions I need with an 8 channel transmitter. Here is my current configuration: - using all 7 transmitter channels for the basic setup with channel 7 assigned to bank switch - using transmitter channel 8 to enable/disable Stabi mode with a 2 position switch - bank 0 setup for Horizon Mode on 3 position switch(position 0) controlling channel 7 - bank 1 setup for Rescue Mode on same 3 position switch(position 1) controlling channel 7 - I want bank 2 to select Return to Home on same 3 position switch(position 2) controlling channel 7 but the Spirit Setting software will not allow me to do this. Since I have used up all my transmitter channels, how to I select Return to Home without another transmitter channel?
Thanks Don
|
|
Top |
|
|
andy6409
|
Posted: Mon 09. Dec 2019 17:38:05 |
|
Joined: Sat 19. Mar 2016 20:32:29 Posts: 96
|
you could free up channel 5 by putting your tail gyro setting directly in the Spirit unit instead of TX then assign a geolink function to channel 5 Other than that you need new TX
|
|
Top |
|
|
DonHoutz
|
Posted: Tue 10. Dec 2019 15:25:14 |
|
Joined: Sun 08. Dec 2019 19:48:46 Posts: 2
|
Yes, that is what I determined, so I had a Spektrum IX12 and began to re-setup the Spirit Pro on this transmitter. Well, while setting up everything, the Spirit Settings software hung up and I had to kill it from my PC and power cycle the Spirit Pro. After powerup, now I cannot get the Spirit Pro to connect to the Geolink. I also noticed the Spirit Pro serial number is ff-ff-ff-ff-ff-1 which is not what it used to be. And finally, the Spirit Pro is not performing any gyro corrections when I tilt the heli. It does talk to the transmitter and the servos move correctly when commanded from the transmitter. Seems like something happened to the Spirit Pro when I powercycled? I tried just about everything but no fixes. I tried reflashing the firmware(2.7.1) which went ok, but it did not correct any of the issues. What should I do?
Tomas: I sent you several personal emails about this. Can you respond to the them?
Thanks Don
|
|
Top |
|
|
ZeXx86
|
Posted: Tue 10. Dec 2019 21:13:53 |
|
|
Site Admin |
Joined: Mon 29. Apr 2013 16:06:44 Posts: 12442
|
Hello,
reply was sent to your email. I believe it will be sorted easily.
_________________ Spirit System developer
|
|
Top |
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
|
Who is online |
|
Users browsing this forum: No registered users and 68 guests |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|