ZeXx86 wrote:
Hello,
this error is very interesting.
Do you have any other servos from other manufacturer? (just one for a simple quick test) no but I can dismount another 700 for test tomorrow
Or could you verify what do you see in the Diagnostic tab? Is some channel at the max position after initialization? I think the problem is there.
What is your receiver type/protocol? I do not understand ? I have a radio JETI
I think that sometime channel is maxed so it is pushing the swashplate to one side. ???
Maybe you have some capacitor or power guard connected? nothing special, it worked well 50 flights now there is the random problem
hello I answer in your text (in red)
When I start if the board is right it flies well, I tried several flights, I turn off and on again sometimes it does not go right, I turn off and on again it's right and I can fly.
In doubt I do not fly for safety even if the board is straight.
I remember that once the helicopter was swaying on the roll just before I landed, I was not too worried thinking about my driving, since I noticed this concern.
