Hi, my question is regarding the above metioned setup.

I use UniSens-E (under Graupner HOTT as GAM)to detect the used capacity and let the receiver tell me by using a switch.
Now - with the sprirt unit i have to decide whether i will use telemetry port for spirit setup or to use the UniSens-E unit.

My question: Is there any possible wireing to have both functions possible via the telemtry port?

regards
Peter

Yes, you can use Y-cable. But before connecting of both components you have to set UnisensE or Spirit to EAM mode instead of GAM.

_________________
TDF, TDR, Logo 600SX, Oxy 4 Max @ 3Digi, VBar Neo, Spirit, Grapuner mz-32, mx-20

See http://manual.spirit-system.com/index.p ... _Emulation how to change sensor emulation mode for Spirit

_________________
TDF, TDR, Logo 600SX, Oxy 4 Max @ 3Digi, VBar Neo, Spirit, Grapuner mz-32, mx-20

this - i will try this - but what about the wires?
The unisons needs the red cable for power-supply. It is recommended that on the SYS-port of the spirit the must not be any voltage!!!

Did you cut the red wire or is it no problem?

Use plus, gnd and signal between Unisens and receiver. And connect signal from receiver to Spirit. GND is already connected by another cable.

_________________
TDF, TDR, Logo 600SX, Oxy 4 Max @ 3Digi, VBar Neo, Spirit, Grapuner mz-32, mx-20

Thank you very much - i will try this!!!

I tried this an it works!!!!!

Great job thank you very much for your help!

Regards
Peter

Hi TomasN,

does it harm to connect GND ? Currently I have connected it and it works.

Thank you in advance for your feedback.

Best, Eugen

Connecting also GND is ok . But single signal wire is enough and simplier.

_________________
TDF, TDR, Logo 600SX, Oxy 4 Max @ 3Digi, VBar Neo, Spirit, Grapuner mz-32, mx-20

Thank you !