Thank you.

That is not your position, but detected position of your internet service provider.
Your position will be visible once you will get a valid GNSS signal.

_________________
Spirit System developer

Hi Tomas,

I too would like to extend my congratulations on yet another superior product developed and produced by Spirit Systems, hats off to you and your team !!! I purchased one yesterday and decided to order another this morning before they get sold out.

Regards,

Kevin

_________________
Blade 230 S / 230 S NF / 450X / 500X / 550X ~ Trex 470LM ~ OXY 3-285 / OXY 4-325 / OXY 4 MAX ~ Spektrum DX9 BE / DX6 Gen 2 ~ Spirit FBL
_______________________________________________
Team OXY Helicopter - Lynx Heli Innovations Field Rep

Hello fellow pilots,

I made a simple demonstration video for you. I am sure others will follow soon.

_________________
"Flying makes me happy" -- Markus Chelios

Very nice demo!

Thanks!

_________________
"Flying makes me happy" -- Markus Chelios

Thank you very much! Very nice!

_________________
Spirit System developer

Today I also installed the new Software and the new firmware on Spirit and Geolink. I used a switch with assigned Return to Home function. When programing the RTH-position by switch it seems to be fine if I look at the moves of the swashplate. But if I have a look the map, the shown position is completely wrong

Can you please elaborate 'wrong' ?
It didn't land where the home position was setup or close to it ?
I haven't had time to setup mine yet,just reading feedbacks and stuff.
Thanks.

Sent from my SM-N950W using Tapatalk

Wrong means in this case about 20 km away - so, positions marked on the map shouldn't be used actually.

Are you really looking at Home position?
Very likely it could be ISP position which is detected from your internet provider. This could fit what you can see.

_________________
Spirit System developer