Thank you for your reply.
In my basic setting (before changing Servos) the left servo is on ch1, the right is on ch3. I think this is correct.
But I tested it out changing servos, but there was no chance to get it work correctly. If I change the servo 1 and 3 it's possible to find a way to steer correctly, but the stabi then works wrong. I can choose if nick or roll compensation is in the wrong way. Both won't be correct. This would be fatal...
So, I think my setting is correct....
Perhaps the scale tail is the issue?
Greetings Andreas
.
Gesendet von meinem SM-G930F mit Tapatalk