Hi,

I'm looking forward to get my Henseleit TDF in a couple of weeks.
I'm wondering which setup I should use to start with, because there is no TDF default setup available in the wizard.

Do I need to change some specific values because of the linear servo drive?

Thanks
Guido

Hi,

you can use TDR profile or Default. Increase Pirouette Consistency to at least 170. Optimal will be probably 175 - 180.

_________________
Spirit System developer

Hi,

Thanks.
I will start with these settings.

Guido

Hi!

There are already new insights for the setup TDF?

Thanks!

Hi,

for linear servos I just recommend to decrease Geometry 6° by approx. 25% since overall gain is too high. This mean that what you will find as a correct value should be then decreased (*0.75).
But all other parameters are similar to other models.

_________________
Spirit System developer

Hello!
How do I get the rear set nicely? I have already set the values very high. Can I still higher?
I'm not quite satisfied with the rear.
It turns a little to the right and at the same time downwards.
Although little, but it could be better!

My file I have attached!

Thank you!

Hello,

what is rear? Is it the rudder?

If yes, have you Gyro Gain configured to work in Head Lock mode?
This can be visible in the Diagnostic tab.

_________________
Spirit System developer

Yes, of course I meant the rudder
I set the values ​​in the transmitter!
In the transmitter I already idle 1 - 75%, idle 2 - 65% and idle 3 - 60%!

That is good, but it still does not mean that rudder will be in Head Lock mode.
For example if you have Futaba, then there could be NORM mode which will set it for Normal mode.
And you want Head Lock.

Please check Diagnostic tab as I have written earlier, only there you will see the mode that will be really used.

_________________
Spirit System developer

Ok,
it is Head Lock!
Rudder Servo is Futaba BLS276