Hi serviceteam,
setting my spirit system (standard) after update - setting channels seams to be fine. Pitch movement is shown at general channel setting as well. But if i try to use pitch under normal circumstances - it doesn't work.
Second - setting direction of each channel has be done and works properly but - if Helicopter will be moved to one site (aileron) Spirit systems moves to same direction - but has to move against this direction
Any idea?
thanks in advance and br
siggi

Direction: This can have different reasons, usual if followed installation wizard, this should work.
Causes, Spirit pointing to wrong flight direction or servo plugged in on wrong ports in Spirit.

_________________
Oxy4max SpiritPro + HW // SOXOS 550, SpiritPro, HW120A V4, 920KV // SOXOS 600, SpiritPro, HW160A, Pyro650 // SOXOS Strike7, SpiritPro, HW160A, Pyro750 // Skywing Spirit Aero // FrSky Horus X10S + Taranis X7 /

Hi Adrian,
I fixed one issue - dircection of contra movement while moving heli has been fixed - I set reverse movement in spirit and normal at TX.
last issue - no pitch movement. Pitch traveling is shown at diagnostic tabs from spirit - therfor signal must be known at spirit

Aileron, elevator, rudder, rescue mode works fine.

Thanks supporting me br siggi

If you're not getting any pitch (collective) you have rescue enabled & active.

Hi jgiannakas,
you are right - I have a mixer at TX and this doesn't work properly (after updating TX Software).
thanks and br
Siggi