Current Spirit Profile Beta prints "Servos ‐> Subtrim ‐> Pitch (CH1)" value of "66" while the value is actually "-66" in software "Spirit Settings v2.2.0".

Used to work fine at least until 19-DEC.

_________________
Oxy 2 ♦ X-Vert ♦ Warp 360 ♦ Blade 450X ♦ Blade 450X Nightflyer ♦ Goblin 500 (RIP) ♦ 2 X mCPX v2 ♦ night fly mQX ♦ LadyMQX ♦ nano QX ♦ nano QX FPV ♦ Inductrix ♦ DX8 G1

Thank you for the message.
We will check it. The software (Spirit Settings) is doing a special reversing depending on the servo reverses, but in case of the viewer it is displaying a raw values (unmodified).

_________________
Spirit System developer

http://4dsviewer.spirit-system.com/www/ ... ?_fid=cq8w
http://4dsviewer.spirit-system.com/www/ ... ?_fid=wdui

For both files, Spirit Software actually shows -66, while the 4dsviewer shows -66 in the first (older) and 66 in the second (newer).

Nothing actually changed in my setup, as far as I know... I went through the setup to redo the servo adjustments after replacing a broken link but in the end I ended up with the same -66 value of adjustment.

_________________
Oxy 2 ♦ X-Vert ♦ Warp 360 ♦ Blade 450X ♦ Blade 450X Nightflyer ♦ Goblin 500 (RIP) ♦ 2 X mCPX v2 ♦ night fly mQX ♦ LadyMQX ♦ nano QX ♦ nano QX FPV ♦ Inductrix ♦ DX8 G1

Thank you very much.

This is really interesting.
I will move the thread to the Wishlist / Bug report section.

_________________
Spirit System developer

I forgot to say that it's probably not a problem of the viewer, since both files are now viewed with the same version of viewer...

_________________
Oxy 2 ♦ X-Vert ♦ Warp 360 ♦ Blade 450X ♦ Blade 450X Nightflyer ♦ Goblin 500 (RIP) ♦ 2 X mCPX v2 ♦ night fly mQX ♦ LadyMQX ♦ nano QX ♦ nano QX FPV ♦ Inductrix ♦ DX8 G1

We will verify it tommorow and let you know. It might be related with profile loading/saving.

_________________
Spirit System developer