It is currently Sat 23. Nov 2024 21:21:49

All times are UTC + 1 hour





Post new topic Reply to topic  [ 10 posts ] 
  Print view Previous topic | Next topic 
Author Message
PostPosted: Sat 27. Aug 2016 0:14:36 
Offline

Joined: Tue 04. Nov 2014 9:54:58
Posts: 87
Updated to 2.1.0
Updated Wifi link to 2.1.0

* Reduced gains to 3/1
* Spools up OK, to 2250
* TH engaged
* Back into ID1 and it spools PAST the max of 2500 into 2700 territory.

Scary!

What gives?

Movie of the process:
https://dl.dropboxusercontent.com/u/421 ... rdness.mov

2nd test after resetting params in CC and checking pole count/kv (not that it appears to be used in CC in fixed endpoint modes):
https://dl.dropboxusercontent.com/u/421 ... 20Same.mov

CC Log after the 2nd run:
https://dl.dropboxusercontent.com/u/421 ... nal%3F.mov

See 52s in. Seems that the CC is seeing throttle stabilising at 1832ms, which differs from the original ID1 1378ms.
I am seeing "rpm signal noisy" in the logs (I didn't see this in 2.0.x)

Using spirit diagnostic, ID1 is 90%. Hold is 12% (1096ms according to CC log). Back into ID1 is still 90%.

Seems to point to Spirit sending a different Throttle signal after coming back of hold?


*** Musings ...
It's almost as if Spirit is doing Gov the first time it sees ID1, but then after entering TH, and reentering ID1 (second time) it's passing through 90% throttle directly to the CC...


Attachments:
File comment: Castle log of the 2nd run
14.2.csv [10.67 KiB]
Downloaded 59 times
File comment: Setup
2.1.0 Gov Gob 570.4ds [255 Bytes]
Downloaded 61 times
Top
 Profile  
 
PostPosted: Sat 27. Aug 2016 1:08:12 
Offline

Joined: Sat 02. Jan 2016 12:17:50
Posts: 183
You can plug in a servo in the ESC port of the spirit and check whether spirit sends out a different signal by how much the horn deflects. Then you'll have narrowed down your investigation at least :) (using a Y lead as you need the motor to spool up as well for rpm sensing to work)


Top
 Profile  
 
PostPosted: Sat 27. Aug 2016 11:10:50 
Offline
Site Admin

Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
Hello,

I think that the problem is here:
Quote:
Using spirit diagnostic, ID1 is 90%. Hold is 12%


Your hold should be always at 0%, else in the next spoolup you will get Autorotation bailout which without blades might cause excess RPM (there is no load).

_________________
Spirit System developer


Top
 Profile  
 
PostPosted: Sat 27. Aug 2016 11:25:25 
Offline

Joined: Tue 04. Nov 2014 9:54:58
Posts: 87
There's no load in ID1 on the first spool either. If load were the issue, surely you'd expect the same to happen for the first spool?

And, it stays constant at 2660-2700 RPM not returning to the indicated head speed. Shouldn't the gov be trying to achieve the target headspeed? I mean, it's a gov right? Not a random number generator? It makes no sense that it'd be staying constant at 2660-2700. Unless it's given up reading the RPM all together because of the "RPM is noisy" states in the log?

btw: Had tails on and it does the same (before I took the video). Granted that's not full load.

I guess I'll go do some more testing. Can't say I'm filled with confidence.


Top
 Profile  
 
PostPosted: Sat 27. Aug 2016 11:32:15 
Offline
Site Admin

Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
If you activate autorotation bailout, it works completely different than normal spoolup.

When target speed is exceeded, it will try to stabilize back normally. But if the noise is present, it will measure that everything is OK and will hold the value.
After initial setting, it will not drop down, else the governor will not work correctly especially when it is unloaded e.g. during falling maneuvers.

But in any way, you should always set hold at 0% - this should solve your problem completely.

_________________
Spirit System developer


Top
 Profile  
 
PostPosted: Sun 28. Aug 2016 10:25:15 
Offline

Joined: Tue 04. Nov 2014 9:54:58
Posts: 87
And with new Gov, will TH of 0% get me AR bailout?


Top
 Profile  
 
PostPosted: Sun 28. Aug 2016 10:33:06 
Offline
Site Admin

Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
To activate autorotation bailout TC should not drop under 12%. For this you can use some switch so you can have 100% control over this.
But this is without any change for a long time.

_________________
Spirit System developer


Top
 Profile  
 
PostPosted: Sun 28. Aug 2016 10:38:39 
Offline

Joined: Tue 04. Nov 2014 9:54:58
Posts: 87
And fro your perspective, should I use the Castle AR bailout at all?


Top
 Profile  
 
PostPosted: Sun 28. Aug 2016 11:17:24 
Offline

Joined: Thu 08. Oct 2015 14:43:12
Posts: 204
Location: Switzerland
scornflake, it's pending on what Mode you use CC, if you use Airplane Mode, you can fully control from Spirit, with danger of ripping gear on wrong manipulation. If you use External Gov Mode, which takes care of slow spoolup on top, you have to use CC Bailout and Spirit Bailout together, as if not enabled in CC, CC will always start with slow Spoolup once Motor stopped.
Have a look on the in dept explanation: viewtopic.php?f=17&t=1364

I'm currently (Yesterday and Today) testing it with FW2.1 on 700 SOXOS with CC Edge HV and its working fine, I had to decrease Gov Holing and Gov Respond by 2 Points. But you also have to take Rampup at or below 100us, if above 100us, Motor won't stop fully on Bailout. Not really an issue taking it down to 100us but there will be a small pause to get first revolutions. Issue is reported to the Dev Team.

_________________
Oxy4max SpiritPro + HW // SOXOS 550, SpiritPro, HW120A V4, 920KV // SOXOS 600, SpiritPro, HW160A, Pyro650 // SOXOS Strike7, SpiritPro, HW160A, Pyro750 // Skywing Spirit Aero // FrSky Horus X10S + Taranis X7 /


Top
 Profile  
 
PostPosted: Sun 28. Aug 2016 21:18:35 
Offline

Joined: Tue 04. Nov 2014 9:54:58
Posts: 87
Adrian,

ahhh. thanks for this info. I hadn't seen this post (don't know why) - looks excellent, I'll go take a read.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 10 posts ] 

All times are UTC + 1 hour


Who is online

Users browsing this forum: No registered users and 20 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  



Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
skymiles_red v1.0.1 designed by Team -Programming forum-سيارات للبيع .