|
It is currently Sun 24. Nov 2024 17:00:57
|
View unanswered posts | View active topics
|
Page 1 of 1
|
[ 1 post ] |
|
Author |
Message |
kumoro
|
Posted: Thu 04. Aug 2016 15:19:58 |
|
Joined: Wed 03. Aug 2016 12:38:29 Posts: 4
|
Hi, Been using Jeti & Spirit Pro for about 6 packs of battery, that is about 20 minutes of flying, so I am consider new to this system. With spirit, mine flies greater than my BD 3SX. The terms here I still dont understand are : 1. Bank, what is that and how to set it (connection) and setup in the software. Is this can be done on Jeti Tx? 2. Gov, I use Hobbywing Platinum 60A v4 that has RPM output. Where should I plug it?I read on the manual, that it goes to middle pin on the ele/pit/ail, while on the ele/ail/pit I have signal cable from my Rx (I use Ex Bus). Can it be joined there, I mean, one plug from Rx goes to inner plug while RPM output from ESC Goes to middle sensor?If I, say, set the max head speed to 2500 and I set 85% on the Tx, would I get 2125 rpm?? Thank you.
|
|
Top |
|
|
|
Page 1 of 1
|
[ 1 post ] |
|
|
Who is online |
|
Users browsing this forum: No registered users and 31 guests |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|