Tail servo is 620 should i use 333h?

Yes, 333Hz is good for this servo.

Rudder Delay should be at 10 to achieve better results.

_________________
Spirit System developer

You were correct by setting the rudder latency to 10 jn the servo to 300hz made the diference.

I got a very very small tail move and imidiate recovery on very hard pitch ups and down

Thanks guys, great support and unit

Perfect,

you are welcome!

_________________
Spirit System developer

Yeap tweaked settings a little more and tail is solid rock no matter what. Only issue now is that when i hit rescue the heli is not going straight up. I checked the swash is level and the heli is initializing on flat surface

Anything else to try?

How many degrees of error?

_________________
Oxy 2 ♦ X-Vert ♦ Warp 360 ♦ Blade 450X ♦ Blade 450X Nightflyer ♦ Goblin 500 (RIP) ♦ 2 X mCPX v2 ♦ night fly mQX ♦ LadyMQX ♦ nano QX ♦ nano QX FPV ♦ Inductrix ♦ DX8 G1

Can you tell me which firmware version do you have and if you are moving with the helicopter after initialization? (before flight).

_________________
Spirit System developer

hello

i have the latest firmware

i have tryed both 1)power up and flight imidietly after init without moving the heli and 2) power up , let it init on the table and move it to flight sight 10 feet away for flight

How many degrees of error?

_________________
Oxy 2 ♦ X-Vert ♦ Warp 360 ♦ Blade 450X ♦ Blade 450X Nightflyer ♦ Goblin 500 (RIP) ♦ 2 X mCPX v2 ♦ night fly mQX ♦ LadyMQX ♦ nano QX ♦ nano QX FPV ♦ Inductrix ♦ DX8 G1

i would say about 10 to 15