Adrian wrote:
Thanks for the video.
Have you tried to connect a Servo to see the signal? I use Spirit Gov with bailout on Ver 2.0 a lot during last weeks and never had any failures or issues.
However I never use airplane mode on my CC EDGE setups, I always use ext Gov with initial Spool up left to ESC for safety but with very fast in Spirit for Bailout.
For general understanding: TC >50% spirit goes into Governor, based on max Head speed multiplied by %, below 50% TC is passed trough.
If once Governor was engaged and TC does not go below 11% next spool up will be Bailout spool up in a 1/3 of initial spool up.
Someone mentioned something about a TC ramp in 100ms instead of jump. Well if TC ramps up to 90% instead of a jump, it going from 0 trough 50% to 90%, asking Spirit to pass trough, causing ESC to Spin somewhere at 40% TC, with Governing later. Could this be the case?
Have you tried to do selective reboot if possible, as effect is only on initial spinnup?
What if only Spirit gets power cycled?
What if only ESC?
What if only RX?
Thanks for your answer.
Actually im uploading a vid right now of exact that spoolup with the pulse checker attached. The spirit is sending 1400us pulse the first release of thr hold! This isnt my esc, thats ruled out, also my futaba I measured, it does nothing weird at all. Vid in aprox 6 minutes.
Your leaving the esc in charge of the spoolup so problems like this will never show up.
I can try to powercycle the spirit after my tx. Esc won't work, it will wait for hold before it initialises.
