Great, was the transmitter started before the unit?

_________________
Spirit System developer

offcourse Always

_________________
[b]-TT E700 V2-Spirit Pro-mks950-980-Kontronik Kosmik 160 HV -Pyro 700 rewound by PD / Voodoo 600 -PD-MX700-470kv--BLS255hv-VBAR 5.3+- Gaui X3+ Spirit Pro

Please check if the governor is active in each bank.

_________________
Spirit System developer

How? Its greyed out, I have the gyro channel set to rescue and don't use banks until we get an 8th channel.

_________________
[b]-TT E700 V2-Spirit Pro-mks950-980-Kontronik Kosmik 160 HV -Pyro 700 rewound by PD / Voodoo 600 -PD-MX700-470kv--BLS255hv-VBAR 5.3+- Gaui X3+ Spirit Pro

Do you need me to check this? I'm sure it's by default settings, I dissabled it from the start. I don't see any option in the software too switch the bank manually.

Verstuurd vanaf mijn HIGHWAY SIGNS met Tapatalk

_________________
[b]-TT E700 V2-Spirit Pro-mks950-980-Kontronik Kosmik 160 HV -Pyro 700 rewound by PD / Voodoo 600 -PD-MX700-470kv--BLS255hv-VBAR 5.3+- Gaui X3+ Spirit Pro

Just to verify - are you starting unit/transmitter with throttle hold active?
Something looks to be out of range during powerup.

If you increase throttle hold position little bit in your transmitter, does it go to 1%? If so, you can return it to 0%.

_________________
Spirit System developer

I always start my transmitter, thr hold on, then I powerup the Spirit. What do you mean 1%?

Verstuurd vanaf mijn HIGHWAY SIGNS met Tapatalk

_________________
[b]-TT E700 V2-Spirit Pro-mks950-980-Kontronik Kosmik 160 HV -Pyro 700 rewound by PD / Voodoo 600 -PD-MX700-470kv--BLS255hv-VBAR 5.3+- Gaui X3+ Spirit Pro

I think that your problem is related with the transmitter configuration.
Our upcoming firmware will not allow to deactivate governor because of this.

I will contact you regarding this with PM so you can try possible solution.

_________________
Spirit System developer

Ok but everyone surely has it like me, nothing weird here.

Verstuurd vanaf mijn HIGHWAY SIGNS met Tapatalk

_________________
[b]-TT E700 V2-Spirit Pro-mks950-980-Kontronik Kosmik 160 HV -Pyro 700 rewound by PD / Voodoo 600 -PD-MX700-470kv--BLS255hv-VBAR 5.3+- Gaui X3+ Spirit Pro

Indeed, something is not correct - most probably from the beginning and this is the reason why you was afraid about fast spoolup.

You can try the easiest things first - for example just reflash the firmware.
Then you might try to open the software and verify, if you can see Requested RPM there (during the first spoolup).
If not, then the problem is really related with the throttle signal.

_________________
Spirit System developer