|
It is currently Sat 23. Nov 2024 6:39:49
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 5 posts ] |
|
| Author |
Message |
|
Scott H
|
 Posted: Fri 09. Oct 2015 12:39:19 |
|
Joined: Wed 24. Jun 2015 4:03:28
Posts: 119
|
|
Is there an explanation for this behavior?
When Stabilization is turned off the throw of the rudder is significantly limited. I'm getting about 1/2 of the expected travel. If I turn on any of the Stabilization modes the rudder slider will travel to the ends of the travel (as I set up in the endpoint settings).
Seems odd to me and I can't figure it out.
|
|
| Top |
|
 |
|
Coco66
|
Posted: Fri 09. Oct 2015 20:36:21 |
|
Joined: Sun 26. Jul 2015 8:17:50
Posts: 433
Location: Madrid, Spain / Torino, Italy
|
|
Is it all happening on the same Bank, or non-Stabilization and Stabilization are on different banks?
_________________
Oxy 2 ♦ X-Vert ♦ Warp 360 ♦ Blade 450X ♦ Blade 450X Nightflyer ♦ Goblin 500 (RIP) ♦ 2 X mCPX v2 ♦ night fly mQX ♦ LadyMQX ♦ nano QX ♦ nano QX FPV ♦ Inductrix ♦ DX8 G1
|
|
| Top |
|
|
|
ZeXx86
|
Posted: Fri 09. Oct 2015 21:20:37 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
The reason for this behavior is, that your Gyro Gain is not same for ON and OFF states.
You should configure same (but opposite) Gyro Gain for the stabilisation as in your normal flight.
_________________
Spirit System developer
|
|
| Top |
|
|
|
Scott H
|
Posted: Sat 10. Oct 2015 0:26:38 |
|
Joined: Wed 24. Jun 2015 4:03:28
Posts: 119
|
|
Thanks, that was it. Much appreciated.
|
|
| Top |
|
|
|
ZeXx86
|
Posted: Mon 12. Oct 2015 10:38:34 |
|
|
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
You are welcome.
_________________
Spirit System developer
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 5 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 26 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
