|
It is currently Sat 23. Nov 2024 0:01:46
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
buttles
|
 Posted: Fri 24. Jul 2015 11:12:36 |
|
Joined: Tue 16. Jun 2015 14:37:10
Posts: 156
|
|
Hi, what does the 'use Bank Switching in Tx' actually achieve? The Lines above it are fine for changing banks for tweaking but the bottom line doesn't enable the Tx assigned switch? Also when trying to save changes I get a double question as in the screenshot. Ignore the Low voltage warning! Thanks, hopefully that makes sense!
| Attachments: |
Screen002.jpg [ 35.19 KiB | Viewed 533 times ]
|
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Fri 24. Jul 2015 11:38:11 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
If you enter Spirit device in the Device Explorer it is very same as when you connect the unit to a PC.
When you are connected and software is running then Bank Switching is performed manually there (by selecting Bank you want). In this time you are unable to change banks with your switch on the transmitter.
So "use Bank Switching in Tx" will close the settings and allow to use assigned switch in your transmitter again.
_________________
Spirit System developer
|
|
| Top |
|
|
|
buttles
|
Posted: Fri 24. Jul 2015 11:48:36 |
|
Joined: Tue 16. Jun 2015 14:37:10
Posts: 156
|
|
Thanks Tomas, that's cleared that one up!
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 63 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
