| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Mixing elevator to flaps in normal mode https://www.spirit-system.com/phpBB3/viewtopic.php?f=35&t=6230 |
Page 1 of 1 |
| Author: | Yogi43 [ Sun 20. Oct 2024 11:57:07 ] |
| Post subject: | Mixing elevator to flaps in normal mode |
Hi, actually I'm setting up the Spirit Aero in a Freewing Avanti v2. When setting the flaps it is required to give 3mm elevator down. Is this also possible in normal mode? I assume in heading-lock mode it is not required. But how does the Spirit behave in normal mode? The separate flaps are controlled by the receiver directly- |
|
| Author: | Yogi43 [ Mon 21. Oct 2024 12:52:06 ] |
| Post subject: | Re: Mixing elevator to flaps in normal mode |
No idea? The next day with good weather conditions I just will try it out. I have defined a trim switch so that I can set the mixing on elevator to zero in case of any problems. |
|
| Author: | ZeXx86 [ Wed 23. Oct 2024 13:23:53 ] |
| Post subject: | Re: Mixing elevator to flaps in normal mode |
Hi, it should work well if the Flaps are controlled from the Receiver directly. Will work with HL or Normal mode. |
|
| Author: | Yogi43 [ Wed 23. Oct 2024 16:45:35 ] |
| Post subject: | Re: Mixing elevator to flaps in normal mode |
Hi, thanks should work means that no elevator mixing is required in HL? What about the mixing in Normal mode? |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|