| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Using separate flap and aileron https://www.spirit-system.com/phpBB3/viewtopic.php?f=35&t=4177 |
Page 1 of 1 |
| Author: | The Da [ Mon 27. Jul 2020 13:42:44 ] |
| Post subject: | Using separate flap and aileron |
From the manual, it seems that when flaps are used with a standard spirit, they get automatically mixed with the ailerons and output to Ch1 and Ch3. Is it possible to have the flaps not mixed and output to a separate channel of the spirit? Like having ch1 for ailerons, ch3 for flaps and ch2 & 4 for elevator and rudder per the manual. This is when using a receiver witth a single line connection like the spektrum 4649T where no rx connections are available to drive servos directly. Also, Aux is to be used for throttle per the manual. |
|
| Author: | ZeXx86 [ Mon 27. Jul 2020 18:12:58 ] |
| Post subject: | Re: Using separate flap and aileron |
Hello, with Spirit 2 or Spirit Pro you can assign a free channel to F: Output to AUX2. This can be used for flaps too. So flaps will be connected at the AUX2 port. |
|
| Author: | The Da [ Mon 27. Jul 2020 19:12:18 ] |
| Post subject: | Re: Using separate flap and aileron |
Ok so it is not possible with standard spirit which is what I already have. It would be nice to have that as a future firmware upgrade as it would allow standard spirit to be a real 6 channels system (one being used for gyro gain). |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|