| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Align BEC RCE-BL60G wiring to Spirit Pro https://www.spirit-system.com/phpBB3/viewtopic.php?f=35&t=3410 |
Page 1 of 1 |
| Author: | philipbunce [ Sun 21. Jul 2019 17:05:59 ] |
| Post subject: | Align BEC RCE-BL60G wiring to Spirit Pro |
ESC wiring query on SpiritPro: I am using the standard Align BEC speed controller (RCE-BL60G) on my Trex 500 but am not sure from the manual the best way to wire this to the Spirit Pro. The manual states that with DSMX satellites (as I am using a DX8 gen2), the throttle is to be connected to the Spirit Pro unit and so am I correct that the wire from the ESC needs to go to the Aux1 unit on my spirit pro Sorry if this is a dumb questions |
|
| Author: | LogoX2 [ Sun 21. Jul 2019 19:56:52 ] |
| Post subject: | Re: Align BEC RCE-BL60G wiring to Spirit Pro |
Yes BEC would get plugged into Aux 1 |
|
| Author: | philipbunce [ Mon 22. Jul 2019 19:38:48 ] |
| Post subject: | Re: Align BEC RCE-BL60G wiring to Spirit Pro |
thanks for this as make sense. So when conecting the esc via the Aux1 port and with this being the the standard Align esc, given that I am using the Spektrum AR8010T receiver (connected vi SRXL port) with telem and my Dx8 gen 2 as a receiver, would i still get access to the battery voltage with this wiring or would i only get access to this if i were to use one of the 6 ESCs listed in the manual? thanks |
|
| Author: | LogoX2 [ Mon 22. Jul 2019 19:46:21 ] |
| Post subject: | Re: Align BEC RCE-BL60G wiring to Spirit Pro |
Correct that ESC does not support Telemetry. You could add a Spektrum Flight Pack Voltage sensor. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|