| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Different channel assignment Jeti EX-BUS? https://www.spirit-system.com/phpBB3/viewtopic.php?f=35&t=2203 |
Page 1 of 1 |
| Author: | stipsi [ Sun 03. Sep 2017 17:46:11 ] |
| Post subject: | Different channel assignment Jeti EX-BUS? |
Have now my Spirit Aero 1.2.0 connected with Jeti EX-BUS. Why does the Rudder have a different channel assignment than in my remote control? In my DC-16 at servo output 4, in the Spirit menu channel 6? This should also be channel 4 or? |
|
| Author: | ZeXx86 [ Sun 03. Sep 2017 18:57:07 ] |
| Post subject: | Re: Different channel assignment Jeti EX-BUS? |
Hello, default channel assignement (in both unit and Jeti radio) should work out of the box. Channel numbers may differ because you can assign to any channel any function in the radio. Also it could differ, because each manufacturer have different layout. So numbers are not important at all. Important is mapped function. You can verify corresponding functions in the Channels window or Diagnostic tab. |
|
| Author: | stipsi [ Sun 03. Sep 2017 19:01:52 ] |
| Post subject: | Re: Different channel assignment Jeti EX-BUS? |
Hello Ok, thank you. I thought just because it matches my 2 Spirit Fbl. Gesendet von meinem GT-I9195 mit Tapatalk |
|
| Author: | ZeXx86 [ Sun 03. Sep 2017 22:33:30 ] |
| Post subject: | Re: Different channel assignment Jeti EX-BUS? |
You can always reassign the channels in the same way as you have it in your other profiles. Then it will be same. In Jeti you can assign any channel to any function. So this could be confusing. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|