Spirit System https://www.spirit-system.com/phpBB3/ |
|
function save model https://www.spirit-system.com/phpBB3/viewtopic.php?f=24&t=6064 |
Page 1 of 1 |
Author: | franz88 [ Sun 21. Apr 2024 7:19:14 ] |
Post subject: | function save model |
with spirit gt/gtr and geolink I would like function save model. The receiver goes into failsafe and activates my function that the model comes home to you (rth) and after automatically (because in fail safe you don't have the controls) the helicopter lands on its own and turns off the engine. Enough just set the failsafe of the channel used to activate this function, for example during failsafe set channel10 at 100% and spirit understands which must be activated. during normal flight channel 10 is set to 0%. go home first and after auto landing and In the end stop motor to turn off the battery |
Author: | HeliMLM [ Fri 03. May 2024 6:55:39 ] |
Post subject: | Re: function save model |
Hello parts of what you are asking is feasible with failsafe - the most important part is auto-motor-off after landing which is not covered. and this one is scary and dangerous at the same time the more important question is the legal aspect: is it legally approved in your country to let a helicopter fly completely autonomously (and covered by insurance)? and this is what you are asking for: autonomous flying. you have to have 100% control over the model at any time and in case of loss of signal, the engine must stop - this is the only safe way. bad for our models - but the only safe way for "the rest of the world". otherwise there is always the question of legal liability in case of accident / damage during autonomous flight... Spirit manufacturer or pilot? and this is most probably the reason that no fbl manufacturer will support such feature in the near future (just compare to automotive ). different story with normal, smaller drones - not even close that dangerous. in my case i.e.: failsafe is >> level the heli, everything to neutral and motor off. |
Author: | Mattes61 [ Sat 04. May 2024 11:34:13 ] |
Post subject: | Re: function save model |
Hello, I agree with HeliMLM that the only thing that is important with a Falisafe is everything on neutral and engine stop, everything else is pretty dangerous - I don't really understand why this is handled differently with drones and I think it is more dangerous than good - Regards |
Author: | Vector [ Sun 05. May 2024 23:48:50 ] |
Post subject: | Re: function save model |
Failsafe is a b**** lol. It will break whole heli from bottom to the top but it is what it is. |
Page 1 of 1 | All times are UTC + 1 hour |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |