|
It is currently Thu 21. Nov 2024 20:01:38
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
kcasser
|
 Posted: Sun 30. Jul 2023 19:56:34 |
|
Joined: Tue 11. Oct 2016 14:35:40
Posts: 22
|
|
I followed the instructions - Set the Throttle Hold curve to 12%, Lowered the Throttle Range to 1070 so that in Throttle Hold the blades stop spinning. Reset everything. Spooled up, clicked Throttle Hold, and the blades kept spinning. They did not slow down. So I recalibrated the esc. Was I supposed to do that? It's not in the instructions.
|
|
| Top |
|
 |
|
kcasser
|
Posted: Wed 02. Aug 2023 0:40:35 |
|
Joined: Tue 11. Oct 2016 14:35:40
Posts: 22
|
|
Now, today, I put it into throttle hold and it kept running at about 300 rpm - not zero. Very weird. What up?
|
|
| Top |
|
|
|
ZeXx86
|
Posted: Tue 08. Aug 2023 13:26:32 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
The ESC shouldn't be recalicated. You might need to decrease Throttle Range - Min. even more until it will stop spinning.
_________________
Spirit System developer
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 25 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
