Spirit System
https://www.spirit-system.com/phpBB3/

Request for Vertical Mount Option
https://www.spirit-system.com/phpBB3/viewtopic.php?f=24&t=4218		 Page 1 of 1
Author:  ahahn61 [ Sat 15. Aug 2020 17:51:36 ]
Post subject:  Request for Vertical Mount Option
Any reason why my preferred mount option is not supported?

I would be happy to have a vertical mount option available.
Attachment:
Spirit_20200815_091002_vertical_mount.jpg
Spirit_20200815_091002_vertical_mount.jpg [ 78.08 KiB | Viewed 524 times ]


best regards
Alois
Author:  ZeXx86 [ Sat 15. Aug 2020 22:38:45 ]
Post subject:  Re: Request for Vertical Mount Option
Hello,

each model has designed spot for gyro mounting. This mounting position is designed so to allow the best conditions for the unit.

Normally any such position is not recommended for a various reasons. For example because aileron axis can achieve the highest vibrations and overal acceleration. Model can do a very sharp movements in this axis. So placing unit in this way will cause to bounce it bigger than when mounted normally.
Also such position is very insecure.
Author:  ZeXx86 [ Sat 15. Aug 2020 22:40:08 ]
Post subject:  Re: Request for Vertical Mount Option
Also I hope you have not connected a Telemetry sensor at the EXT/RPM/E2 port. This will cause crash. E2 pin should be unused.
Author:  ahahn61 [ Sun 23. Aug 2020 10:55:59 ]
Post subject:  Re: Request for Vertical Mount Option
ZeXx86 wrote:
Hello,

each model has designed spot for gyro mounting. This mounting position is designed so to allow the best conditions for the unit.

Normally any such position is not recommended for a various reasons. For example because aileron axis can achieve the highest vibrations and overal acceleration. Model can do a very sharp movements in this axis. So placing unit in this way will cause to bounce it bigger than when mounted normally.
Also such position is very insecure.

Thanks for the information!
Author:  ahahn61 [ Sun 23. Aug 2020 11:04:11 ]
Post subject:  Re: Request for Vertical Mount Option
ZeXx86 wrote:
Also I hope you have not connected a Telemetry sensor at the EXT/RPM/E2 port. This will cause crash. E2 pin should be unused.

Thanks for the hint, I noted the issue at another post.

You should put an explicit warnig to the instructions page, that other E2 pins must stay unconnected, otherwise a crash will result.
http://manual.spirit-system.com/index.php?title=SpiritRS_Telemetry

http://manual.spirit-system.com/index.p ... _Telemetry
Attachment:
2020-08-23_11h58_12.png
2020-08-23_11h58_12.png [ 85.37 KiB | Viewed 472 times ]
Author:  ZeXx86 [ Mon 24. Aug 2020 10:27:17 ]
Post subject:  Re: Request for Vertical Mount Option
Yes, the warning is also at the wiring page.
Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/