ZeXx86 wrote:
Hello,
I am not sure why your question is in this section, but can you tell me what does mean when it is "not working"?
Do you mean it does not work at all?
You can easily verify in which mode the unit is, what feature is engaged at the Aid tab. It must be active.
Tomas I apologize if I posted in the incorrect section, I wasn't sure so I posted here. I also apologize if I wasn't clear with the issue I'm having. What's happening is when I have position hold and altitude hold assigned to separate switches the heli ascends rapidly upon activating altitude hold AFTER activating position hold. It does this using "On 1/+100%" and "On2/-100%" switch position. I have since assigned position hold and altitude hold on the same switch and it now holds altitude with position hold but only in the "On 1/+100%" position. If I set up the switch for position hold and altitude hold to the 'On 2/-100%" position the heli still ascends rapidly. Correct me if I'm wrong but I believe with altitude hold set to "On 2/-100%" the heli should hold the altitude of when it was activated and not allow altitude changes with the collective. All of the features I've set up are responding exactly as set in Spirit Settings/Aid Tab and not activating any unintended features such as altitude limit. I'm only using position hold and altitude hold, no Stabi/Rescue or any other features.
and it does this on both the +100 and the -100 position. Any ideas on why this happens? I've tried lowering the vertical gain from 80 (default setting?) to 50, the lowest it will let me with the same results. I don't have any Stabilization engaged and since the heli flies great otherwise and practically hovers hands off I'm pretty sure it's nothing mechanical. I've calibrated the compass and it's reading dead on 90* when facing north. So far the only features I've tried are Stabi (normal), Position Hold and Altitude Hold. 