| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Prevent motor spool-up when connected to USB/Bluetooth/Wifi https://www.spirit-system.com/phpBB3/viewtopic.php?f=24&t=3283 |
Page 1 of 1 |
| Author: | jjuk [ Wed 24. Apr 2019 16:27:58 ] |
| Post subject: | Prevent motor spool-up when connected to USB/Bluetooth/Wifi |
The motor only needs to spool-up when configuring the governor, so a tick box in the governor setup screen to enable the motor would be good to stop accidental spool-ups. The motor will turn off when governor setup screen is exited. In all other screens, the motor will ALWAYS be disabled, regardless of throttle setting on the Tx. |
|
| Author: | Shonkonray [ Thu 25. Apr 2019 8:07:06 ] |
| Post subject: | Re: Prevent motor spool-up when connected to USB/Bluetooth/W |
Then you wouldnt be able to use the vibration analysis! |
|
| Author: | jjuk [ Thu 25. Apr 2019 9:51:34 ] |
| Post subject: | Re: Prevent motor spool-up when connected to USB/Bluetooth/W |
Shonkonray wrote: Then you wouldnt be able to use the vibration analysis! Ah yes, forgot about that. Enable the motor for that test too. But everything else should be disabled. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|