|
It is currently Fri 22. Nov 2024 6:51:52
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 2 posts ] |
|
| Author |
Message |
|
ferdey
|
 Posted: Thu 10. Jan 2019 0:09:41 |
|
Joined: Thu 10. Jan 2019 0:03:35
Posts: 39
|
|
Hi,
I am having problem with failsafe values on a Spirit non-pro. I have throttle at 0% and pitch at 50% (0 degrees) and I hit the "set" button for failsafes and save on the backup tab. I have tried this 3 times. The blades are visually at 0 degrees. When I disconnect and test, the blades are noticeably at quite high pitch, nothing like they were when I saved the values. What may cause this?
Thanks,
Rob
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Thu 10. Jan 2019 9:25:37 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
Hi,
it is dependent on your receiver/radio.
Some radios are storing its own Failsafe in the receiver as well.
So there are two failsafes.
You might need to reprogram the failsafe in your radio as well.
To test failsafe from Spirit unit just plug off the RX cable from unit.
_________________
Spirit System developer
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 44 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
