|
It is currently Fri 22. Nov 2024 6:53:08
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 2 posts ] |
|
| Author |
Message |
|
Coco66
|
 Posted: Wed 24. Feb 2016 18:05:58 |
|
Joined: Sun 26. Jul 2015 8:17:50
Posts: 433
Location: Madrid, Spain / Torino, Italy
|
|
Hi, I have the feeling that in Servo Travel Correction the Maximum and the Minimum are swapped.
My non-zero values are for low stick but they appear here in the first part, the Maximum area. I think they should be shown below in the Minimum area.
One other small thing... with 2.0.0 the Failsafe information can be saved to the unit (for some receiver typoes), but I don't see it here in the printed settings detail. Would be nice to have.
_________________
Oxy 2 ♦ X-Vert ♦ Warp 360 ♦ Blade 450X ♦ Blade 450X Nightflyer ♦ Goblin 500 (RIP) ♦ 2 X mCPX v2 ♦ night fly mQX ♦ LadyMQX ♦ nano QX ♦ nano QX FPV ♦ Inductrix ♦ DX8 G1
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Thu 25. Feb 2016 9:50:02 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
Hi,
thank you for the report.
This issue is caused because of your special firmware where it must be swapped because of your rotor head.
So it is not officially supported yet.
_________________
Spirit System developer
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 41 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
