| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Governor calibration https://www.spirit-system.com/phpBB3/viewtopic.php?f=24&t=1083 |
Page 1 of 1 |
| Author: | cycled [ Mon 07. Dec 2015 11:24:02 ] |
| Post subject: | Governor calibration |
It is not obvious how to calibrate the "governor min" and "max" fields to the required values. I suggest that there be "set" buttons, such that the user (1) disables ESC/motor, (2) sets radio to min value (i.e. throttle hold), (3) presses "set min", (4) sets max value (full throttle), (5) presses "set max" in the GUI. Further, I do not like the current failsafe value. Currently it seems to output a very low value (maybe -150%) when signal is lost, which is acceptable but annoying (ESC constantly beeps). Earlier I had it outputting full throttle when signal was lost! (This was when I was adjusting the throttle min/max points in the governor GUI.) The fail-safe position should either be min-throttle or be adjustable by the user! While you're at it, please allow calibration of all channels. It would make set-up much easier. |
|
| Author: | ZeXx86 [ Mon 07. Dec 2015 11:38:42 ] |
| Post subject: | Re: Governor calibration |
Upcoming version will bring many changes, including different Throttle Range settings. So everything mentioned is significantly improved. |
|
| Author: | ZeXx86 [ Mon 07. Dec 2015 11:53:01 ] |
| Post subject: | Re: Governor calibration |
What receiver type do you using? |
|
| Author: | cycled [ Mon 07. Dec 2015 15:27:53 ] |
| Post subject: | Re: Governor calibration |
Brilliant. Gr-12L. The problem started when I accidentally reset the receiver (I use a receiver mixer to set throttle range so that it shows up correctly on the TX) and had to recalibrate channels. I checked without the Spirit connected, and the failsafe was doing the right thing (I used a servo as a "PWM meter" instead of the motor). |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|