| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Wish/Suggestion: Failsave at PPM https://www.spirit-system.com/phpBB3/viewtopic.php?f=24&t=1008 |
Page 1 of 1 |
| Author: | beko [ Sat 31. Oct 2015 20:33:09 ] |
| Post subject: | Wish/Suggestion: Failsave at PPM |
Hallo, I think it would be useful when the Spirit would handle the Failsave on Throttle in PPM - Connection in the same Way as in the several BUS - Connections. I use a Jeti RSat2 in PPM-Mode and need also Telemetry, so there is no way to connect Sprit via EX-Bus (exept buying new REX-Receiver). Would this be possible? Thanks Bernd |
|
| Author: | ZeXx86 [ Sat 31. Oct 2015 21:16:27 ] |
| Post subject: | Re: Wish/Suggestion: Failsave at PPM |
Hello, you can configure Failsafe in Jeti transmitter. Failsafe is supported with PPM as well. Actually Jeti Rsat2 support EX Bus connection as well, which is much better solution. |
|
| Author: | beko [ Sat 31. Oct 2015 22:46:15 ] |
| Post subject: | Re: Wish/Suggestion: Failsave at PPM |
ZeXx86 wrote: you can configure Failsafe in Jeti transmitter. Failsafe is supported with PPM as well Thanks for quick response. I know about the possibility of using EX Bus. It works well, also when the Cable between Rx and Spirit breaks. But EX Bus only is available at Ext-Port, so the Option of Telemetry is not more given (with RSat2). If I use PPM and configure Failsave in the RSat2 it works also, with the Exception of a Cable-Fail. I proove it, but the Motor (of course) stay running. Would it be much work to implement Failsave at PPM in the same way as in EX Bus (taking the Throttle Failsave-Value on Initialisation)? Best Regards Bernd |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|