|
It is currently Sun 24. Nov 2024 8:09:02
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 5 posts ] |
|
| Author |
Message |
|
Peter Zimmer
|
 Posted: Sun 08. Aug 2021 20:49:37 |
|
Joined: Sun 08. Aug 2021 17:57:29
Posts: 4
|
|
I like to operate a "lost beeper" at AUX2, but AUX2 supports the servo signal with 200 Hz. The frequency has been verified with an oscilloscop. Changing the frequency of the swash blade and tail servo to 50 Hz has no effect. A SAVOX servo works well on AUX2. The "lost beeper" works well with a servo tester at 50 Hz.
I expect there is a bug in the firmware.
I use the Spirit 2
Firmware: Spirit Heli 3.3.1
Spectrum with 2 SATs
Chanel 8 is configured for output on AUX2
|
|
| Top |
|
 |
|
swash23
|
Posted: Mon 09. Aug 2021 7:33:13 |
|
Joined: Fri 01. Nov 2019 13:32:19
Posts: 40
Location: Munich, Germany
|
|
Hello, did you try to change the throttle frequency in the "Governor / Throttle" menu?
|
|
| Top |
|
|
|
Peter Zimmer
|
Posted: Mon 09. Aug 2021 18:10:57 |
|
Joined: Sun 08. Aug 2021 17:57:29
Posts: 4
|
|
Hello swash23,
in the throttle menu, the frequency is 60 Hz and the ESC works fine.
Regards
Peter
|
|
| Top |
|
|
|
Peter Zimmer
|
Posted: Mon 09. Aug 2021 18:29:18 |
|
Joined: Sun 08. Aug 2021 17:57:29
Posts: 4
|
|
Hello,
I just updated to 3.3.2, changed the throttle frequency Form 60 Hz to 200 Hz, saved it to the Spirit and changed it back to 60 Hz with saving to the Spirit.
My problem that the beeper isn't working at AUX2, is still there.
|
|
| Top |
|
|
|
Peter Zimmer
|
Posted: Sat 16. Oct 2021 11:22:26 |
|
Joined: Sun 08. Aug 2021 17:57:29
Posts: 4
|
|
I've made a interface circuit out of an Arduino Nano. Now it works.
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 5 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 8 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
