Spirit System
https://www.spirit-system.com/phpBB3/

SRXL2 Technology
https://www.spirit-system.com/phpBB3/viewtopic.php?f=21&t=3640
Page 1 of 6

Author:  ragge1 [ Sat 16. Nov 2019 21:48:45 ]
Post subject:  SRXL2 Technology

hi will Spirit support the new spektrum SRXL2 protocol
will this rx be compatible :

http://spektrumrc.com/Products/Default. ... D=SPM4651T

Author:  ZeXx86 [ Sat 16. Nov 2019 22:30:24 ]
Post subject:  Re: SRXL2 Technology

Yes, it will be compatible.

Author:  Torpicaltrail [ Tue 26. Nov 2019 1:13:16 ]
Post subject:  SPM4651T SRXL2 Remote Serial Receiver with Telemetry

The new SRXL2 Remote Serial Receiver with Telemetry (SPM4651T) looks interesting. However, Spektrum and Horizon have limited information.

How will it connect to Spirit? What cable(s) needed?

HH website lists "SRXL2 Remote Receiver Extension", available in several lengths on the product page below, but no pictures and no instructions.

https://www.horizonhobby.com/srxl2-remo ... y-spm4651t

Thanks

Author:  TDNKKK [ Sat 30. Nov 2019 3:14:11 ]
Post subject:  SRXL2 Technology

ZeXx86 wrote:
Yes, it will be compatible.


SRXL2 remote receiver uses a 4-pin connector (not 3-pin). How are we going to connect it to the satellite ports on the Spirit 2?

Image

Author:  tfmcnellist [ Wed 04. Dec 2019 4:46:24 ]
Post subject:  Re: SRXL2 Technology

Here is the manual.
https://www.spektrumrc.com/ProdInfo/Fil ... ual-EN.pdf

Author:  ZeXx86 [ Wed 04. Dec 2019 10:27:17 ]
Post subject:  Re: SRXL2 Technology

It will be connected in the similar way as SPM4649T.

Author:  TDNKKK [ Wed 04. Dec 2019 14:23:07 ]
Post subject:  Re: SRXL2 Technology

ZeXx86 wrote:
It will be connected in the similar way as SPM4649T.


Tomas, will you make multi adapter with 4-pin heads?



Sent from my iPhone using Tapatalk

Author:  TDNKKK [ Tue 24. Dec 2019 2:36:52 ]
Post subject:  SRXL2 Technology

So, it looks like the new SPM4651T also makes use of the NC port/wire. If we are told that it works the same way as the SOM4649T, then does that mean we should ignore the “NC” wire and connect the other three (Volt, Signal, GND) to the Jeti cable just like the spm4649? Please advise.

Thanks
Image

Author:  ZeXx86 [ Tue 24. Dec 2019 14:38:50 ]
Post subject:  Re: SRXL2 Technology

Hello,

N/C mean Not Connect.
Yes, we will make adapter for the new receivers. So that it can be easily plugged to the unit.
Support will be included very soon.

Author:  RV1TD [ Tue 24. Dec 2019 17:06:47 ]
Post subject:  Re: SRXL2 Technology

Great, thanks! Will look forward to seeing an update in the manual

Page 1 of 6 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/