|
It is currently Sun 24. Nov 2024 10:48:13
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 8 posts ] |
|
| Author |
Message |
|
Adam
|
 Posted: Sat 22. Nov 2014 20:24:24 |
|
Joined: Sat 22. Nov 2014 19:54:36
Posts: 2
|
|
I have had 2 flights with my T-Rex 500 this afternoon, so far i am impressed with the Spirit unit. My question is "is there a way to soften the feel on the cyclic around the centre?" On the AR7200bx i use dual rates and expo in flight mode 0 so that take off an landings are easy. I noticed on landing the heli was very twitchy/reactive. I thought i might tip it over. however in idle 1 while doing lookps rolls flips etc the feel was excellent. So is there a dual rate or expo i could use in the and switch using the banks or can i use it in the Tx?
thanks
_________________
Align T-Rex 600 EFL (DFC)
Align T-Rex 500 ESP With SPIRIT
Old Skool TT Raptor 30 with Flybar
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Sat 22. Nov 2014 20:57:40 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
With Spirit you can use Expo from transmitter without any issue as the unit does not use any internal expo.
Microbeast has its own expo built-in so there is a difference.
Also be sure your Rotation rate is not too high (not higher than necessary) else feel around center will be inprecise.
Also to achieve similar behavior you probably want to decrease Cyclic Feed Forward parameter (values between 4-5 should be similar to Microbeast). For Flight Style default settings are fine if you want to achieve similar flight behavior.
So you can freely set cca 25-30% TX Expo.
_________________
Spirit System developer
|
|
| Top |
|
|
|
Jman841
|
Posted: Sun 23. Nov 2014 16:31:51 |
|
Joined: Thu 31. Jul 2014 21:27:22
Posts: 215
|
|
Not to derail this thread but I see this quite often... What is CCA?
|
|
| Top |
|
|
|
ZeXx86
|
Posted: Sun 23. Nov 2014 17:03:59 |
|
|
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
_________________
Spirit System developer
|
|
| Top |
|
|
|
ritchieicu
|
Posted: Sun 23. Nov 2014 21:03:46 |
|
Joined: Thu 28. Aug 2014 18:17:19
Posts: 90
|
|
Means there or thereabouts
|
|
| Top |
|
|
|
Jman841
|
Posted: Mon 24. Nov 2014 3:06:14 |
|
Joined: Thu 31. Jul 2014 21:27:22
Posts: 215
|
|
| Top |
|
|
|
Adam
|
Posted: Thu 27. Nov 2014 17:56:13 |
|
Joined: Sat 22. Nov 2014 19:54:36
Posts: 2
|
|
on the Android App for the Spirit i noticed that there is an agility parameter. But in the PC software there isn't. I assume that it is the parameter is the Rotation Speed. I currently have that set at 8.
If i reduce the rotational speed will that act the same as lowering the rates. I can then put this on a bank switch and use the low rates to land and carry out hovering maneuvers, then switch to a higher rate to carry out flips and rolls.
_________________
Align T-Rex 600 EFL (DFC)
Align T-Rex 500 ESP With SPIRIT
Old Skool TT Raptor 30 with Flybar
|
|
| Top |
|
|
|
ZeXx86
|
Posted: Thu 27. Nov 2014 18:08:59 |
|
|
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
Hi,
thank you, there is probably translation issue, but both are same parameters, so it should correspond to Sensor tab.
Yes, rotation rate parameter is inteded for this. Your steering should be more precise with lower values.
_________________
Spirit System developer
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 8 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 4 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
