Spirit System
https://www.spirit-system.com/phpBB3/

rotation rate of the flip to recover the heli.
https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=940		 Page 1 of 1
Author:  icare [ Sat 03. Oct 2015 18:23:12 ]
Post subject:  rotation rate of the flip to recover the heli.
Hi
I have tried the rescue with my logo 600 (firmware 1.3 and red spirit) It works perfectly in acro mode, but in normal mode , and when I activated the rescue in inverted flight (normal mode) , I was very surprised by the rotation rate of the flip to recover the heli skids down. It is almost violent.

I tried 2 or 3times, but I stopped because I was afraid to boom strike my logo... :(

Is it possible to adjust the rotation rate of this flip, other than reducing the cyclic ring setting ?
Author:  scrambled [ Sat 03. Oct 2015 20:53:46 ]
Post subject:  Re: rotation rate of the flip to recover the heli.
It's quick but nowhere near problems.
Your Logo will have no issues with it!
Author:  Hakan [ Sun 04. Oct 2015 0:43:44 ]
Post subject:  Re: rotation rate of the flip to recover the heli.
Lower the cyclic ring, at least that is what I had to do. My 450 allowed very large defelctions and I followed the manual and set up max possible. That rescue flip was fast and violent!
Author:  icare [ Sun 04. Oct 2015 7:03:50 ]
Post subject:  Re: rotation rate of the flip to recover the heli.
Hakan wrote:
Lower the cyclic ring, at least that is what I had to do. My 450 allowed very large defelctions and I followed the manual and set up max possible. That rescue flip was fast and violent!


Yes I agree with you.
May be I am wrong, but I feel the rescue flip is even faster with the new firmware 1.3.

It would be nice to have the possiblilty to slow down a little the rescue flip ( in rescue normal mode) with a suitable setting.
Author:  kramrle [ Sun 04. Oct 2015 20:16:30 ]
Post subject:  Re: rotation rate of the flip to recover the heli.
+1 for a submenu in which we can trim the flip rate from inverted to skid down.
Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/