| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| spirit 1.3 gov setting https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=930 |
Page 1 of 1 |
| Author: | walle999 [ Thu 01. Oct 2015 22:48:34 ] |
| Post subject: | spirit 1.3 gov setting |
Hi there i wonder what the refresh rate should be on castle edge series speed controllers it say on there home page "ESC now supports, and USES, high frequency receiver pulses (100+ hz). In previous versions of firmware, receiver input was processed at 50hz." from version 4.0 and higher, but what value should i use in spirit gov. can a to high value damage or make any illeffects if its not supported by the esc? Best regards Niclas |
|
| Author: | ZeXx86 [ Fri 02. Oct 2015 7:25:53 ] |
| Post subject: | Re: spirit 1.3 gov setting |
Hi, ESC shouldn't be damaged, but some problems may occur. Mostly it is strange spoolup behavior if there is any used by the ESC. I recommend to not use higher frequency than 200Hz for any ESC and examine if it is not too hot. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|