| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| New Firmware - what to reconfigure? https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=928 |
Page 1 of 1 |
| Author: | Malc1 [ Thu 01. Oct 2015 13:28:07 ] |
| Post subject: | New Firmware - what to reconfigure? |
I've still not test flown my new TRex 700 Nitro due to issues reading RPM's and therefore uneven engine speeds. If I flash the new firmware before I test fly again what do I need to reconfigure? Anything? |
|
| Author: | ZeXx86 [ Thu 01. Oct 2015 13:57:02 ] |
| Post subject: | Re: New Firmware - what to reconfigure? |
You do not need to do any reconfiguration if you are not using Governor from the unit. If so, then you will need to re-configure Max. parameter, Spoolup rate, Governor Response and Holding performance and to enable Governor in the Bank you wish (mostly all banks). |
|
| Author: | Malc1 [ Thu 01. Oct 2015 13:59:50 ] |
| Post subject: | Re: New Firmware - what to reconfigure? |
Yes I will be using the Nitro governor. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|