File is .4df instead of .bin, roughly 120KB instead of around 50KB, and no published checksum... sure?

_________________
Oxy 2 ♦ X-Vert ♦ Warp 360 ♦ Blade 450X ♦ Blade 450X Nightflyer ♦ Goblin 500 (RIP) ♦ 2 X mCPX v2 ♦ night fly mQX ♦ LadyMQX ♦ nano QX ♦ nano QX FPV ♦ Inductrix ♦ DX8 G1

I just flashed it... Going to the field right now. I'll let you know in
about 20 minutes

Sent from my XT1254 using Tapatalk

Please check our release notes, you can find more details about the new firmware format here.

_________________
Spirit System developer

It flies! Don't forget to re-enable your governor after the update.... And download the new software on your phone if you're using it

Sent from my XT1254 using Tapatalk

Just wondering, did you unplug all the cables from the unit before carrying out the update?

Nope... Just plugged in the USB cable

OK I have downloaded the file but am unable to update the unit as the firmware update software is only looking for a .bin file.
There is no option to search for any other type.

Windows XP. Any ideas?

You have to download and install also the new software.
Old software does not support new firmware format.

_________________
Spirit System developer

OK will try this now.

Updated successfully and Nitro governor set up again.

On the bench the first thing I've noticed is that the throttle servo still goes over to full throttle but it no longer pulses continuously when it gets there.

I'm using a Jeti DS16,do I need to update a file for this to work correctly?