ALIGN HE50H22
| Attachments: |
|
$_1.JPG [ 11.57 KiB | Viewed 926 times ] |
| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Align governor sensor polarity https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=908 |
Page 1 of 1 |
| Author: | lenny53d [ Wed 23. Sep 2015 20:42:30 ] |
| Post subject: | Align governor sensor polarity |
I wanted to make sure I understood the forums I have seen on this topic. The align governor sensors: Black wire needs to receive positive voltage and Red wire needs to receive negative voltage There backwards. The white wire is signal? And it runs best on around 3.3 volts? Thanks Larry |
|
| Author: | Coco66 [ Wed 23. Sep 2015 20:55:18 ] |
| Post subject: | Re: Align governor sensor polarity |
Can you post the exact name and model number of the sensor? |
|
| Author: | lenny53d [ Wed 23. Sep 2015 21:37:40 ] | ||
| Post subject: | Re: Align governor sensor polarity | ||
ALIGN HE50H22
|
|||
| Author: | Coco66 [ Wed 23. Sep 2015 21:42:15 ] |
| Post subject: | Re: Align governor sensor polarity |
I would 100% trust the BeastX guys: http://wiki.beastx.com/index.php/MICROB ... r_(HE50H22)/en |
|
| Author: | ZeXx86 [ Thu 24. Sep 2015 9:19:16 ] |
| Post subject: | Re: Align governor sensor polarity |
Yes, you are right. Black wire is +, red wire is -. You can connect it to the unit directly so that the red wire will be in the center and black on the side. If you can check the manual, there is described polarity of the connector. |
|
| Author: | lenny53d [ Thu 24. Sep 2015 14:35:49 ] |
| Post subject: | Re: Align governor sensor polarity |
Thank you for the help! Larry |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|