| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Setting up nitro governor - on the bench behaviour https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=880 |
Page 1 of 1 |
| Author: | Dawiev [ Fri 11. Sep 2015 17:33:22 ] |
| Post subject: | Setting up nitro governor - on the bench behaviour |
Hi, when I activate the governor on the bench, without the engine running, the first part of the throttle behaves as expected. However, once I go past the point where the governor engages, the servo keeps creeping up to 100%. It does not stop at the throttle percentage in the curve (flat curve and the percentage doesn't make a difference). Is this normal / expected ? Is it simply because the unit is not getting an RPM signal ? |
|
| Author: | Scott H [ Fri 11. Sep 2015 18:02:21 ] |
| Post subject: | Re: Setting up nitro governor - on the bench behaviour |
normal |
|
| Author: | ZeXx86 [ Sun 13. Sep 2015 10:17:25 ] |
| Post subject: | Re: Setting up nitro governor - on the bench behaviour |
Yes, it is because motor is not spinning so it is trying to increase the throttle to get more RPM, but there is no feedback all the time. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|