Spirit System
https://www.spirit-system.com/phpBB3/

Spirit gets no voltage, no red LED ...
https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=847
Page 1 of 1

Author:  Franky13 [ Thu 20. Aug 2015 19:31:28 ]
Post subject:  Spirit gets no voltage, no red LED ...

Hello Thomas!

According to the new firmware version 1.2.1 I have no power in the Spirit?
Have some trials started, no success.
The red LED is off!
Where is the problem?

Greeting Frank

Author:  ZeXx86 [ Thu 20. Aug 2015 19:45:10 ]
Post subject:  Re: Spirit gets no voltage, no red LED ...

Hello Frank,

it seems that flashing process was not successfull so that is the reason why unit is not working.
Did you checked the firmware file (checksum) before update?

It is possible to flash the firmware again in recovery mode if this is the case.

Author:  Franky13 [ Thu 20. Aug 2015 20:04:13 ]
Post subject:  Re: Spirit gets no voltage, no red LED ...

OK,
but how can I reset the Spirit again?
I can not open the software ...

Author:  ZeXx86 [ Thu 20. Aug 2015 21:22:05 ]
Post subject:  Re: Spirit gets no voltage, no red LED ...

I have sent you PM with the guide for flashing in the special mode.

Author:  Franky13 [ Fri 21. Aug 2015 6:12:01 ]
Post subject:  Re: Spirit gets no voltage, no red LED ...

Hello Thomas!
Thanks for the instructions but I think that I will send you the Spirit.
how do we go on?

Greeting Frank

Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/