| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Nitro Throttle fully closed trim position - tx setup https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=840 |
Page 1 of 1 |
| Author: | Malc1 [ Sun 16. Aug 2015 14:24:04 ] |
| Post subject: | Nitro Throttle fully closed trim position - tx setup |
Addition setup help with reference to my other thread. Is the correct setup procedure for this to have the throttle to be fully shut at 0 trim position on the transmitter or a - trim value below this? My fully closed throttle trim position is currently -40. I normally raise it a few points towards 0 to get the engine to idle. Just wondering if I need to adjust my TX's throttle channel end points to give the 0 - 100 throttle in the software with the throttle trim at 0 and then use the governor min tab to fully reduce it further to close the throttle fully? Just clarifying a basic setup point - to be sure. |
|
| Author: | ZeXx86 [ Sun 16. Aug 2015 19:49:42 ] |
| Post subject: | Re: Nitro Throttle fully closed trim position - tx setup |
It will work in both ways. There are no special requirements. |
|
| Author: | Malc1 [ Sun 16. Aug 2015 20:07:33 ] |
| Post subject: | Re: Nitro Throttle fully closed trim position - tx setup |
Ok thanks. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|